You won’t find a better wheel hanger to help with installing the wheels on your European car than the stainless steel lug bolt guide tools offered by Reverse Logic Limited. The tools feature a pilot tipped thread for easy alignment in the lug bolt holes. The bull-nosed tip and smaller diameter on the outer end facilitate sliding the wheel over the tool. The knurl provides a finger grip surface that is inset from the tip to avoid damaging the finish on your wheels. The tool length of 117mm can accommodate aluminum wheels with deep lug bolt holes.

Available in M12x1.5, M14x1.5, and M14x1.25 thread sizes. Consult the chassis compatibility tables on the Lug Bolt Guide Tools page to determine the thread size required for your European car.

The chassis specific tools hang from the jack points of your car and prevent damage to the side skirts and undercarriage of your car while using a floor jack.

Our latest jack pad tool for Corvette C5/C6 chassis incorporates an innovative T-nut which allows the tool to be used in one of two ways. It can be suspended from the jack point or secured in place for extended maintenance periods.

Our tools with spring loaded bullet latches fit most Mercedes-Benz chassis introduced after the 2000 model year. Late model BMW and MINI Cooper chassis and the Nissan GT-R will accept our jack pad tools with silicone plugs which retain the tools in place.

Our multi-vehicle jack pad tool can be used with just about any BMW or Mercedes as well as the Nissan GT-R. This tool is available with an optional 30mm pin for use with floor jacks which have a removable saddle.

Trademark acknowledgments. C-Class, CL, CLK, CLS, E-Class, GL-Class, M-Class, Mercedes-Benz, R-Class, S-Class, and SLK are registered trademarks of Daimler AG Corporation. The BMW name, model names, and logo are registered trademarks. The MINI name, MINI COOPER, MINI COOPER S, and logos are registered trademarks. GT-R is a registered trademark of Nissan Motor Co., Ltd. Race Ramps, Trak-Jax and Flatstoppers are trademarks of Brute Industries, Inc.

Copyright © 2007, 2008, 2009, 2010, 2011 Reverse Logic Limited. All rights reserved.

1. 56” & 67” Standard Race Ramps with 10.7º Constant Slope
   

2. 72”, 80”, & 87” 2-Stage Incline Ramps with 6.8º Initial Incline
   

3. 89” & 99” Progressive Incline Curved Top Ramps for Very Low Cars
   

4. Flatbed Extension Ramps, 5000 lb/Pair Capacity, 5.2º Incline

Race Ramps - The Premier Ramp Solution for Low Ground Clearance Cars

on late model BMW, MINI, Mercedes-Benz, and Nissan GT-R chassis. The powder coated aluminum blocks are 52mm long by 30mm wide by 28mm high. They are bolted to the jack stand saddle with an M10x1.5 bolt and can be removed if necessary.

Since the jack stands are positioned inside the vehicle jack pocket, they will be in the ideal location for supporting the weight of the car without damaging the jack points.

Custom Torin Jack Stands for BMW, MINI, MB

& Nissan GT-R Jack Points

Do-it-yourselfers who are passionate about their cars will appreciate the innovative and practical solution that Reverse Logic jack pad tools offer.

The Torin T43004 aluminum jack stands with aluminum jack stand blocks fit into the plastic jack points

Two ramps in one! Invertible incline sections double as 6” high trailer ramps. Model RLL-80-2 two-stage incline Ramps available 14-Jan-2013.

9” high cradle top